Or (with auto detect wireless interface name): Sudo ip link set wlp2s0 down & sudo iw wlp2s0 set monitor control & sudo ip link set wlp2s0 up It is usually done with the following command: (mac80211 monitor mode vif disabled for wlan0mon)ĭon't forget to restart the network manager. (mac80211 station mode vif enabled on wlan0) Phy0 wlan0mon ath9k_htcĚtheros Communications, Inc. If airodump-ng, aireplay-ng or airtun-ng stops working afterĪ short period of time, you may want to kill (some of) them! It can also be done manually by running the following command:įound 5 processes that could cause trouble. When putting a card into monitor mode, it will automatically check for interfering processes. Phy0 wlan0 ath9k_htcĚtheros Communications, Inc. “check kill” will check and kill off processes that might interfere with the aircrack-ng suite.Ĭheck status and/or listing wireless interfaces It is strongly recommended that these processes be eliminated prior to using the aircrack-ng suite. “ check” will show any processes that might interfere with the aircrack-ng suite.optionally set the card to a specific channel.indicates if you wish to start or stop the interface.Entering the airmon-ng command without parameters will show the interfaces status. It may also be used to go back from monitor mode to managed mode. This script can be used to enable monitor mode on wireless interfaces.
0 kommentar(er)
